The Think Tank

I made a small change to my anchor last night, so that the knuckles on both my middle and index fingers straddle either side of the point of my jaw bone. I think this might help to eliminate or at least reduce tipping the release at different angles.

I sped the release up quite a bit. I moved the small mark on it to line up with the centerline, but that was a bit too fast. I tweaked it a couple times but now the mark is around 7:30 (with the blue side to the right).

Result: getting through my shot a little faster. Not inking much about thumb placement.

Creed tune revealed a slight variance so I added .5 twists to the string.

Result: no variances in vertical placement during creep tune.

I removed 4 twists. (May have only been 3.5).

Result: feels better, especially with new change to cable length as the result of the creep tune test.

I lowered the rest to accommodate the 2712s and 150gr points. I’m not sure how many lines I adjusted it, but the old values are marked. It is now on the 4th line from the top.

I also made a minor change to the horizontal setting, moving it IN about 1 full line and then an additional line-width.

Arrow Shaft
A/C/C 3-39 @ 29.75″ – 100gr

Draw Length
30.5″

Draw Weight
56 lbs.

Axel-to-Axel
42″  –  Top of top pin to center of bottom pin

Peep Sight
14.625mm  –  Front of T-square resting on the center of the nock

Tiller
Top/Bottom: 23mm
Outside of string, measured from front of T-square

Rest
Horizontal: 29mm  –  Measured from end of T-square
Vertical: 28.9mm  –  Measured from end of T-square
From String: 18.5mm  –  Front of T-square to tips of Launcher

Nock Point
Top:  -3.25mm  –  Inside edge with T-square @ lowest point in V of rest
Bottom: -7.5mm  –  Inside edge with T-square @ lowest point in V of rest
D-Loop: 1/2 inch – from outside of string to inside of D-Loop

Cable Guard
Position: Flush to front of riser
Control Yoke: Outside slot on slider
Bus Cable: Inside slot on slider

Wheels:
Top At Rest

Bottom At Rest

Top At Full Draw

Bottom At Full Draw

Stabilizer
Kudalec 4-Rod

Stabilizer Weights:
All weights measured to center of set-screw

First: Small steel – 3 ^11/16 inches from front of stabilizer
Second: Large Aluminum – 13 ^3/16 inches from front of stabilizer
Third: Large Aluminum – 23 ^9/16 inches from front of stabilizer